:	Jul 4, 2005

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the transmission.

.

: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination. Remove the gear position sensor.   Remove the 2 Torx screws.   Remove and discard the O-ring seal.

.

Install the gear position sensor.   Clean the component mating faces.   Install a new O-ring seal.   Apply sealant to the Torx screw thread.   Tighten the Torx screws to 10 Nm (7 lb.ft).

.

Install the transmission.

.

Connect the battery ground cable.